9.A1D1 Cembre EWO IP66 Grey 1 hole 1 - 2mm cable clamp Grommet For Split Cable Entry Systems

Why Choose the Cembre EWO 9.A1D1 IP66 Grey 1 Hole 1 - 2 mm Cable Clamp Grommet

The Cembre 9.A1D1 is a grey single hole cable clamp grommet for EWO split cable entry systems. It securely seals and supports one pre terminated cable in the 1 - 2 mm diameter range, helping you preserve the enclosure’s IP66 integrity and deliver a clean, professional finish.

Built to the EWO Type A small module format, the 9.A1D1 drops into the frame from above during final assembly. If your layout changes later, simply swap grommets without reworking the panel cut out or removing connectors from the cable end.

Key Features

• 1 hole grommet for a single cable sized 1 - 2 mm.
• Integrated clamp profile grips the sheath for strain relief and sealing.
• Type A small module, nominal 20 × 20.6 mm.
• Supports system IP66 when used with EWO frames with overmoulded seal.
• Fast drop in assembly for pre terminated cables, no rework of cut outs.
• Grey colour for easy circuit identification; black options available in the range.

Technical Specifications

• Manufacturer: Cembre
• Series: EWO split cable entry system
• Model: 9.A1D1
• Function: Type A single hole cable clamp grommet
• Cable diameter range: 1 - 2 mm
• Module size: 20 × 20.6 mm (Type A)
• Material: Thermoplastic elastomer (TPE)
• Colour: Grey
• System ingress protection: IP66 with a compliant EWO frame
• Typical operating temperature (system): frame −40 to +140 °C; grommets suitable for industrial environments
• Approvals: Part of an EWO family with UL and RINA approvals
• Notes: Mix with other Type A grommets to match your cable set. Replace later without disturbing the wiring.

Certifications

When installed in an EWO frame, the system achieves IP66 sealing via the frame’s overmoulded gasket. EWO frames and grommets are supported by industry approvals used across the range.

Comparison and Selection Notes

Choose 9.A1D1 for a single 1 - 2 mm cable. For larger single cable diameters see 9.A1D* variants. For two or four cables in the same footprint select 9.A2D* or 9.A4D*. Use 9.AD0 to blank unused positions.

Frequently Asked Questions

• What is the 9.A1D1 used for
• Which frames does it fit
• Does it maintain IP66
• Can I swap it later for a different size

Applications

• Instrumentation and sensor leads in compact control cabinets.
• Signal wiring and fine harnesses where small diameters are common.
• OEM equipment needing tidy pre terminated cable routing with sealing and strain relief.

Trusted By Panel Builders

"Holds tiny sensor leads firmly without deforming the sheath, and keeps the frame sealed." Panel Builder, UK