TS20524AS - RUBBER ROLL LEV RESET BUTT LEFT 1NO+1NC

Why Choose the TS20524AS?

Engineered for dependable position sensing, the Lovato TS20524AS limit switch combines a roller lever with an integrated RESET button for clear acknowledgement. Part of the T series with dimensions to EN 50041, it features 1NO+1NC snap action contacts and a rubber Ø50 x 10 mm roller. A polymer thermoplastic housing and TS2 designation support consistent switching in automated equipment.

Installation and wiring are straightforward via the PG13.5 cable entry, while the device operates from -25 to +70 °C to suit varied environments. Rated Ith 6 A and tested for 100000 mechanical cycles, it meets IEC/EN 60947 and related standards. This metal and plastic limit switch is suitable for end-of-travel detection, repeatable signalling, and simple manual reset in control and automation applications.

Key Benefits

• Roller lever with rubber Ø50 x 10 mm for smooth, reliable actuation.
• Integrated RESET button enables quick manual acknowledgement on site.
• 1NO+1NC snap action contacts provide crisp, consistent switching.
• PG13.5 cable entry simplifies installation and cable management.
• Operates from -25 to +70 °C for wide ambient suitability.
• Mechanical life of 100000 cycles supports dependable service.
• Dimensions to EN 50041 aid compatibility with standardised layouts.
• Conforms to IEC/EN, UL508 and CSA standards for broad compliance.

Technical Specification

• Product type designation: TS2
• Ith (IEC): 6 A
• Weight: 145 g
• Mechanical life: 100000 cycles
• Operating temperature: -25 to +70 °C
• Storage temperature: -40 to +70 °C
• Pollution degree: 3

What’s Included

• Lovato TS20524AS limit switch unit
• Pre-fitted roller lever with rubber Ø50 x 10 mm roller
• Integrated RESET button
• Manufacturer documentation

Applications

• End-of-travel detection on conveyors and machinery
• Position sensing in automated equipment and assemblies
• General-purpose limit switching in control systems
• Installations using EN 50041 dimensional form factor
• Processes requiring manual reset acknowledgement via button

Safety note: Install and commission only by qualified personnel. Isolate power before wiring, respect the 6 A Ith rating and temperature limits, use a suitable PG13.5 gland, and follow applicable IEC/EN standards and manufacturer instructions.