P1RC2P25A030 - RES.CURRENT DEV.2P 25A IDN 30MA TYPE A

Why Choose the P1RC2P25A030?

The Lovato residual current operated circuit breaker P1RC2P25A030 delivers dependable residual protection in a compact, 2‑module format. This 2‑pole, Type A device is rated at 25 A with a 30 mA I∆n, aligning with IEC/EN/BS 61008‑1 requirements. With Ui 400 V and 4 kV impulse withstand, it suits modern distribution assemblies where reliable fault detection and clear, compliant specification are essential.

Engineered for resilience, it operates from -35 to +70 °C and maintains IP20 frontal protection, with performance tested up to 2000 m altitude. Low 0.5 W max power dissipation per pole supports efficient panel design, while secure terminations tighten to 1.8–2 Nm. At just 185 g and 2 DIN modules wide, it integrates neatly into space‑constrained assemblies.

Key Benefits

• Compact 2 DIN‑module width for efficient panel space usage.
• 2‑pole configuration for use on two‑pole circuits.
• Type A residual operation characteristic as specified.
• 25 A rated current supports common circuit requirements.
• 30 mA rated residual current I∆n for clear specification.
• Ui 400 V and 4 kV impulse withstand capability.
• Wide -35 to +70 °C operating temperature range.
• IP20 frontal degree and low 0.5 W per pole dissipation.

Technical Specification

• Rated insulation voltage Ui (IEC/EN): 400 V
• Rated impulse withstand voltage Uimp: 4 kV
• Power dissipation per pole (max): 0.5 W
• Operating temperature: -35 to +70 °C
• Storage temperature: -40 to 80 °C
• Max altitude: 2000 m
• Terminal tightening torque: 1.8 to 2 Nm
• Weight: 185 g
• IP degree (frontal): IP20
• Pollution degree: 2

What’s Included

• Lovato residual current operated circuit breaker, SKU P1RC2P25A030
• Manufacturer’s documentation (datasheet/specification)
• Protective packaging for transit

Applications

• Type A residual current protection on two‑pole circuits up to 25 A
• Distribution and control assemblies requiring 2 DIN‑module devices
• Installations built to IEC/EN/BS 61008‑1 conformity
• Panels operating in -35 to +70 °C environments
• Projects needing IP20 frontal protection and 400 V insulation rating

Safety note: Install and commission only by a qualified person. Isolate all power sources before work, observe the specified torque and ratings, and comply with IEC/EN/BS 61008‑1 and local regulations.