P1RA2P40A030 - RES.CURRENT DEV.2P 40A IDN 30MA ADD ON BLOCK

Why Choose the P1RA2P40A030?

Lovato’s P1RA2P40A030 residual block delivers dependable residual protection in a compact, 2-module format. This 2P, Type A device is rated 40A with a 30mA IΔn and conforms to IEC/EN 61009-1. With Ui 400 V, Uimp 4 kV and an IP20 frontal degree, it’s a robust choice for compact installations requiring reliable residual current protection.

Engineered for dependable service, it operates from -25 to +60 °C and up to 2000 m altitude, with a mechanical life of 20,000 cycles. Terminal tightening torque of 1.8 to 2 Nm supports secure connections, while its 160 g build and pollution degree 2 rating suit compact assemblies. Storage is rated -40 to +80 °C, helping maintain performance across demanding installation schedules.

Key Benefits

• 2P, Type A characteristic for specified residual protection performance.
• 40 A rated current with 30 mA IΔn sensitivity.
• Compact 2 DIN-module width optimises panel space.
• Conforms to IEC/EN 61009-1 for recognised compliance.
• Ui 400 V and 4 kV Uimp enhance electrical robustness.
• IP20 frontal degree for basic ingress protection at the face.
• Wide -25 to +60 °C operating temperature range.

Technical Specification

• Rated insulation voltage Ui (IEC/EN): 400 V
• Rated impulse withstand voltage Uimp: 4 kV
• Operating temperature: -25 to +60 °C
• Storage temperature: -40 to +80 °C
• Max altitude: 2000 m
• Terminal tightening torque: 1.8 to 2 Nm
• Mechanical life: 20000 cycles
• Weight: 160 g
• IP degree (frontal): IP20
• Pollution degree: 2

What’s Included

• Lovato P1RA2P40A030 residual block
• Mounting and installation leaflet
• Safety and compliance information

Applications

• Two-pole circuits requiring 40 A, 30 mA residual protection
• Systems specifying a Type A residual operation characteristic
• Compact boards needing a 2-module residual block
• Assemblies designed to IEC/EN 61009-1 requirements
• Installations within -25 to +60 °C and up to 2000 m altitude

Safety note: Install and commission only by qualified personnel with power isolated. Tighten terminals to 1.8 to 2 Nm and follow IEC/EN 61009-1 and site safety procedures.