M1R00912048A7 - DOL STARTER M1R 48/50-60 2 5-4A

Why Choose the M1R00912048A7?

Designed for reliable motor control, the Lovato Direct-on-line Starter M1R00912048A7 combines an IP65 enclosed housing with an integrated thermal overload relay and a prominent RESET pushbutton. It uses a BF09/BF18 contactor driven by a 230VAC 50/60Hz AC coil for straightforward installation. Suited to demanding environments, this enclosed direct-on-line starter delivers robust protection and simple operation in a compact footprint.

Performance is assured with AC-3 Ie 4A/1.5kW at 400V and UL/CSA 2HP at 480V ratings, while the thermal overload relay provides up to 1.6A max (0.37...0.55kW at 400V). Built for -25 to +60 °C operation, it conforms to IEC/EN 60947-1 and 60947-4-1, plus UL508 and CSA C22.2 n° 14, supporting compliance across varied installations.

Key Benefits

• IP65 enclosed housing for dust-tight protection and water jet resistance.
• Integrated thermal overload relay with easy RESET pushbutton recovery.
• BF09/BF18 contactor with 230VAC 50/60Hz AC coil for simple control.
• AC-3 rated 4A/1.5kW at 400V for dependable motor starting.
• UL/CSA 2HP at 480V aligns with international compliance needs.
• Operates from -25 to +60 °C for reliable service in harsh environments.
• Conforms to IEC/EN 60947 and UL508, easing specification and approvals.

Technical Specification

• Weight: 995 g
• Operating temperature: -25 to +60 °C
• Storage temperature: -40 to +70 °C

What’s Included

• Lovato enclosed direct-on-line starter assembly (IP65)
• Integrated thermal overload relay, 1.6A max
• BF09/BF18 contactor fitted
• RESET pushbutton on front cover

Applications

• DOL starting of motors up to 1.5kW at 400V (AC-3)
• Equipment needing IP65 enclosed control in dusty or wet environments
• Systems with a 230VAC 50/60Hz control supply
• Installations requiring IEC/EN 60947 or UL508/CSA compliance
• General industrial start/stop control with thermal overload protection

Safety note: Install and commission only by a qualified electrician. Verify the control voltage and thermal overload setting suit the motor and application, and isolate power before any work, following applicable standards.