LVMP10A024 - PRIORITY CHANGE RELAY 24VAC

Why Choose the LVMP10A024?

Lovato LVMP10A024 is a modular start-up priority change relay for dependable load sequencing and redundancy management. Operating at 24VAC with two relay outputs, it helps initiate a stand‑by motor when required and streamline start-up priorities. Designed for DIN rail installation, this LVMP10 series device suits control panels where compact, reliable start-up priority change relays are needed to maintain process continuity and reduce manual intervention.

With an Ith of 8 A and a rated impulse withstand voltage of 4 kV, the LVMP10A024 is built for robust performance. It operates from -20 to +60 °C and features a maximum terminal tightening torque of 0.8 Nm. Conformity includes IEC/EN 60255-5, 61000-6-2, 61000-6-3, plus UL508 and CSA C22.2 n° 14, supporting global panel compliance.

Key Benefits

• Two relay outputs for reliable load sequencing and standby motor initiation.
• 24VAC rated supply integrates with common control circuits.
• Modular DIN rail mounting simplifies installation and panel layout.
• 8 A Ith provides robust switching capability for control applications.
• 4 kV impulse withstand voltage enhances surge and transient immunity.
• Wide -20 to +60 °C operating range suits varied environments.
• Tested to IEC/EN, UL, and CSA standards for assured compliance.

Technical Specification

• Product type designation: LVMP10
• Ith (IEC): 8 A
• Terminal tightening torque (max): 0.8 Nm
• Rated impulse withstand voltage Uimp: 4 kV
• Operating temperature: -20 to +60 °C
• Storage temperature: -30 to +80 °C
• Weight: 250 g

What’s Included

• LVMP10A024 start-up priority change relay (modular unit)
• Installation instructions
• Safety and compliance documentation

Applications

• Start-up load priority control in motor control panels
• Automatic starting of a stand-by motor when required
• Sequencing dual loads to balance runtime and availability
• DIN rail control cabinets requiring compact change relays

Safety note: Install and commission only by qualified personnel. Isolate the 24VAC supply before wiring, observe the 0.8 Nm maximum terminal tightening torque, and follow the listed standards and local regulations.