ADXNP01824 Lovato SOFT STARTER 18A AUX 24VAC/DC ADVANCED

Why Choose the ADXNP01824?

Lovato’s ADXNP01824 is an advanced ADXNP soft starter with an integrated by‑pass relay for dependable, controlled starts. It runs on a 24VAC/DC auxiliary supply and works across 208–600VAC rated operational voltage, with an 18A rating. Offering starting settings for fine‑tuning and straightforward panel integration, the ADXNP01824 suits UK industrial control applications that prioritise consistency, compliance and clean installation.

Engineered to meet IEC/EN/BS 60947-1 and 60947-4-2, plus UL and CSA counterparts, this Lovato soft starter carries IP20 protection and is suited to Pollution degree 2 environments. Its −30 to +80 °C storage range aids logistics and site staging. With the ADXNP designation and a Sustainability certification, it integrates cleanly into compliant control panels where 24VAC/DC auxiliary control and wide 208–600VAC supply compatibility are required.

Key Benefits

• Advanced ADXNP soft starter with integrated by‑pass relay built in.
• Wide 208–600VAC operational voltage range for flexible installation.
• Auxiliary supply 24VAC/DC supports varied control system architectures.
• 18A rating suits appropriately sized controlled starting applications.
• IP20 protection suitable for enclosure‑mounted control gear.
• Compliant with IEC/EN/BS, UL and CSA standards for assurance.
• Storage from −30 to +80 °C simplifies transport and stocking.
• Pollution degree 2 suitability for typical industrial panel environments.

Technical Specification

• Product type designation: ADXNP
• Storage temperature: -30 to +80 °C
• Pollution degree: 2
• IP degree of protection: IP20

What’s Included

• Lovato ADXNP01824 soft starter unit with integrated by‑pass relay
• Manufacturer quick start and safety information
• General panel mounting and wiring guidance
• Protective packaging for transport and storage

Applications

• Controlled motor starting where 208–600VAC supply ranges are present
• Panels requiring 24VAC/DC auxiliary control for soft start devices
• Installations following IEC/EN/BS 60947-4-2, UL and CSA requirements
• Environments consistent with IP20 and Pollution degree 2 classifications

Safety note: Install and commission only by qualified personnel in accordance with applicable standards and the manufacturer’s documentation. Verify correct wiring, protective devices and environmental conditions before energising.