HSDW3-24 Partex adhesive-lined 3:1 heat shrink, 24/8mm, pack Length

Why Choose the Partex HSDW3-24 Adhesive-Lined 3:1 Heat Shrink Tubing?

The Partex HSDW3-24 is a professional adhesive-lined 3:1 heat shrink tubing designed for electrical insulation, cable protection and sealing of compatible electrical connections. Featuring a nominal supplied diameter of 24 mm and a recovered diameter of 8 mm, this dual-wall heat shrink tubing provides a practical solution for protecting cable joints, electrical terminations and wiring assemblies.

Unlike conventional single-wall heat shrink tubing, the adhesive-lined construction incorporates an internal adhesive layer that softens during heating, helping form a protective seal between the tubing and the underlying cable or component. This provides additional protection against moisture ingress and environmental exposure when the tubing is correctly selected and installed.

With its 3:1 shrink ratio, the HSDW3-24 accommodates a wider range of cable and connector dimensions than comparable 2:1 tubing. It is particularly useful for electrical maintenance, industrial control panel wiring, machinery installations and cable repairs where insulation, mechanical protection and additional sealing are required.

Key Advantages

• 3:1 shrink ratio accommodates a wide range of compatible cable and connector diameters.
• Adhesive-lined construction helps create a protective seal around cables and electrical connections.
• 24 mm supplied diameter allows installation over appropriately sized cable joints and terminations.
• 8 mm nominal recovered diameter enables close-fitting protection around smaller cable sections.
• Dual-wall design combines an outer heat shrink sleeve with an internal adhesive lining.
• Helps protect electrical connections against moisture ingress, abrasion and everyday environmental exposure.
• Provides a neat, professional finish for cable repairs, electrical installations and industrial maintenance.

Key Features

• Partex HSDW3-24 adhesive-lined heat shrink tubing.
• 3:1 nominal shrink ratio.
• 24 mm nominal diameter before shrinking.
• 8 mm nominal recovered diameter.
• Internal adhesive lining for additional sealing around compatible cables and components.
• Dual-wall heat shrink construction for insulation and protective covering.
• Heat-activated shrinkage and adhesive sealing.
• Suitable for electrical cable joints, terminations and repair applications.
• Useful for industrial control panels, machinery wiring and electrical maintenance.
• Accommodates changes in diameter across appropriately sized cable connections.

Adhesive-Lined Cable Protection for Industrial Electrical Systems

Adhesive-lined heat shrink tubing provides a convenient method of insulating and sealing electrical connections. When suitable heat is applied, the outer sleeve contracts around the cable or component while the internal adhesive softens and flows into compatible surface gaps. As the assembly cools, the adhesive helps establish a protective bond, reducing potential paths for moisture ingress. The Partex HSDW3-24 offers a nominal reduction from 24 mm to 8 mm, making it suitable for installations with varying cable and connector diameters.

This combination of insulation and sealing is useful in industrial automation equipment, electrical control systems, machinery wiring and cable maintenance. The HSDW3-24 can be used to protect appropriately sized cable joints and terminations where conventional unlined heat shrink tubing may not provide sufficient environmental sealing. Installers should ensure that the tubing can pass over the largest component before shrinking and recover sufficiently around the smallest section. Any required voltage rating, operating temperature or environmental protection classification should be confirmed against the applicable manufacturer documentation before use.

Typical Applications

• Electrical cable joint insulation and sealing.
• Protection of cable terminations and connector transitions.
• Industrial control panel wiring and electrical assemblies.
• Machinery wiring and automation equipment maintenance.
• Cable sheath repairs and protective coverings.
• Electrical installation and maintenance work.
• Wire harness protection and cable assembly finishing.
• Connections requiring additional protection against moisture ingress.